AIT Thesis no.ST-20-02
Development of preplaced lightweight aggregate concrete
by Wasuchart Chiemchit
|
AIT Thesis no.ST-20-03
Active control of aerodynamic flow around structures by using plasma actuators
by Phasuthorn Phiwphong
|
AIT Thesis no.ST-20-04
A study of hydraulic cement and Its application in concrete mixture optimisation using particle packing models
by Mazumdar, Aaquib Rasul
|
AIT Thesis no.ST-20-05
Effect of polymer admixtures on flexural properties of preplaced aggregate concrete
by Minsar, Mohamed Aslah Mohamed
|
AIT Thesis no.ST-20-06
Modeling of flexural-dominated composite shear walls
by Ghani, Muqtadir
|
AIT Thesis no.ST-20-07
Effect of torsional sensitivity on the performance-based seismic design of tall buildings
by Thiri San
|
AIT Thesis no.ST-20-08
Seismic response assessment of block-type building contents in tall buildings
by Natthapong Nima
|
AIT Thesis no.ST-20-09
Seismic perfromance assessment of low-rise buildings subjected to repeated earthquakes
by Giri, Suyog
|
AIT Thesis no.ST-20-10
Seismic performance assessment of a high-rise building subjected to repeated earthquakes
by Rajbhandari, Merit
|
AIT Thesis no.ST-20-11
Reinforced concrete beam-column joint simulation under reversed cyclic loads using layered-shell elements In SAP2000
by Sthapit, Ronit
|
AIT Thesis no.ST-20-12
Enhancing the seismic performance of tall buildings with outrigger systems using viscoelastic coupling dampers
by Krishnakumar, Thanirosan
|
AIT Thesis no.ST-20-13
Evaluation of nonlinear seismic response of mid-rise buildings with RC walls and infill walls by using a modified response spectrum analysis (MRSA) method
by Pradhananga, Anuj
|
AIT Thesis no.ST-20-14
Evaluation of nonlinear seismic responses of low- to mid-rise RC frame buildings with masonry infill walls by using a modified response spectrum analysis (MRSA) method
by Bhattarai, Kapil
|
AIT Thesis no.ST-20-15
Implication of performance-based design on resilience and cost of a tall building in the Philippines
by Gautam, Angshuman
|
AIT Thesis no.ST-20-16
A comparison of accidental eccentricity due to influencing factors with code-based approach
by Karunarathna, Pindeniya Appuhamilage Sarala
|
AIT Thesis no.ST-20-17
Calibration of structural models using measured building response
by Sapkota, Ashish
|
AIT Thesis no.ST-20-18
Seismic performance improvement of existing highway bridges by base isolation approach
by Nat Hanwiboonwat
|
AIT Thesis no.ST-20-19
Seismic performance evaluation of steel diagrid system for tall building in high wind and seismic region
by Seng Sorpichkapoun
|
AIT Thesis no.ST-20-20
Evaluation of seismic damage of tall buildings from acceleration response time histories by a modal decomposition approach
by Chananwath Sinthumongkhonchai
|
AIT Thesis no.ST-20-21
Evaluation of equivalent static wind forces for low-rise building from simultaneous pressure measurement data
by Piyawich Tanburinthip
|