1 AIT Asian Institute of Technology

Improve the machinability of aluminum with the assistance of electricity

AuthorVashistha, Ritukar
Call NumberAIT Thesis no.ISE-13-24
NoteA thesis submitted in partial fulfillment of the requirements for the degree of Master of Engineering in Mechatronics
PublisherAsian Institute of Technology
Series StatementThesis ; no.ISE-13-24
AbstractThe goal of this thesis is to study the improvement of machinability of the Aluminum with the assistance of electricity. The process performance of milling on depth of cut and feed rate was determined. Minitab software was used to obtain the best cutting condition with a minimal number of experiments. In these experiments, cutting speed, feed rate, cutting tool material, depth of cut and the current were found to affect the specimen surface roughness. Then, the optimized values of all parameters were obtained.
Year2013
Corresponding Series Added EntryAsian Institute of Technology. Thesis ; no. ISE-13-24
TypeThesis
SchoolSchool of Engineering and Technology (SET)
DepartmentDepartment of Industrial Systems Engineering (DISE)
Academic Program/FoSIndustrial Systems Engineering (ISE)
Chairperson(s)Bohez, Erik L. J.;
Examination Committee(s)Mongkol Ekpanyapong ;Chana Raksiri;
Scholarship Donor(s)Asian Institute of Technology Fellowship;
DegreeThesis (M.Eng.) - Asian Institute of Technology, 2013


Usage Metrics
View Detail0
Read PDF0
Download PDF0